The doorway width - the width from flange to flange of your doorway - needs to be between 23-3/4 inches and 26-1/4 inches, so yes, your 24 inch door will allow you to use the MORryde steps you asked about, which are the following part number:
- MORryde StepAbove RV Steps - 2 Steps # MR26RR
The only other thing you need to be sure of is the entry height (which is measured from the doorway threshold on your camper to the ground), as the # MR26RR is for entry heights measuring from 25 inches... view full answer...
To know if the Adjustable Width Trailer Hitch Receiver for RVs, 22" to 66" Wide # C13704 will fit your 2019 Winnebago Minnie Travel Trailer you'll need to measure the distance between the frame beams. If the measurement you get falls in the 22" - 66" range you will be able to install this hitch. This RV receiver hitch has a 5,000lbs GTW and 500lbs TW.
If the frame width is greater than 66" then we have the Adjustable Width Trailer Hitch Receiver for RVs # 13703 which has a frame width... view full answer...
The best storage cover for your 2018 Winnie Mini Drop 1790 is Adco Olefin part # AD37ZR as this provides the best protection in hot climates with a lot of sun, has the easiest install, and also has zipper panels that allow for easy access to the doors of the RV if ever needed.
I attached a review video for this for you to check out as well. view full answer...
There is one but it does not fit in the space in the same way. The only replacement converter that is designed to fit in your WF-8955PEC power center is item # PD4655V. However, it doesn't work with Lithium batteries. You should be able to install the Progressive Dynamics Inteli-Power RV Converter and Battery Charger item # PD9160ALV in the space your current converter sits in.
It wasn't designed to be mounted into your power center but we've seen it done on a few trailers so I know it's... view full answer...
Is there anyway to get your bikes under 40 lbs like maybe by removing the seats and/or batteries? If so, there's a really easy solution with the Lippert Bike Wing Adapter part # LC731137 since your trailer has the Jack-It adapter mounted to the jack flange.
Other than that there really isn't a great bike rack solution since you'd need so much extension for your bike rack to fit and clear the trailer jack unless you'd consider a front hitch for the truck or there was a hitch at the rear... view full answer...
Hey Libby, so a 18k btu AC unit is going to need right at 1,900 watts running and 3,700 watts startup. Most CPAP machines draw between 30 and 60 watts and the TV is most likely right at 68 but it wouldn't hurt to verify. So 2,000 running watts 4,000 starting is going to be about right for you.
So the Champion generator part # CH44FR would be a great choice. It has an inverter for clean power so your TV and CPAP will work well and it can be ran on propane or gas. view full answer...
We've had customers with your same 2018 Winnebago Minnie 170S confirm that the lift kit part # LC270682 is correct and that the axle configuration was a 3,500 diamond Lippert axle. This would be the kit you'd need to give you a lift of 3-1/2 inches. view full answer...
Go To Results